Looking for a wireless light switch?

In houses in the 1800s, it was typical to have a lamp just run on whale oil. You would just put the oil in the fixture and you would turn the valve up or down to control it. Then, gas came along and you’d have a similar process and use a valve to turn it up or down. Now, with electricity, we’d usually have to use wiring to connect the fixture and the switch. However, due to the structure of the house, it’ll be too complicated and costly to add wiring. So instead, we installed a wireless light switch.

Looking for a wireless light switch? Ebelong has developed a compact, wireless, batteryless pushbutton controller that transmits a 12-bit digital ID code to the vicinity when it is pressed.

Ebelong wireless kinetic switch is a creative and unique switch that can be used in homes, offices, and other places.

A wireless light switch, also known as a remote light switch, works with a device that has a wireless antenna and a switch. The device is installed into the canopy of the light fixture. Then, the wireless switch is attached to the wall. With just a simple push of a button, the switch sends the wireless signal up to this antenna to turn on or off the light. The best part? There are no batteries needed.

No Battery, No Wiring & No WiFi Required- Innovative kinetic energy technology to produce electricity, the switch can be installed anywhere without running additional wires; No need to connect Wi-Fi or tear walls; save material cost & engineer labor fee!

Secure Wireless Signal – Encrypted wireless signal can go through walls without interference problems, unique communication code between switch and receiver; 30M indoor using, outdoor up to 160M transmission distance.

Ebelong wireless light switch is a light switch that commands a light or home appliance to turn itself off or on, instead of interrupting the power line going to the light fixture. There are different ways to communicate between the switch and the fixture, They are easy to Install – No power needed, no complicated setup, only two easy steps for installation & pairing:

（1） A radio receiver is typically wired or screwed into a fixture or device, wired or otherwise connected to the electrical system of the building, or plugged into an outlet. The radio receiver’s memory is programmed by any number of means to respond to certain selected “switches” or (more correctly) remote control transmitters.

（2）Using the existing power lines, A receiver is plugged into an outlet and a device is then plugged into the receiver. The plug-in receiver is then programmed to the switches. Some devices are hard-wired into ceiling light fittings, making for a hidden system.

Advantages of using Ebelong’s wireless switches include:

Wireless – No piping or wiring required.

Eco-friendly – No battery, no dust, no construction waste.

Maintenance-free – No need to ever change the battery.

Water-resistance – The switch can work in a wet environment (IP65).

Long-range – The reliable RF remote control extends 30m indoor and 100m outdoor.

Memory function – Remembers previous settings.

Flexible pairing – Create multi-location switching.

Easy installation – takes only 5 minutes to install, with no battery, no WiFi, no BLE, no app required.

Durable – 50 years mechanical lifetime of the switch.

Cost-saving – Saves 30% compared to a traditional switch. Reduces manual labor and decreases construction costs by 30%.